For small holes up to approximately ½” you may merely use spackling compound and a putty knife. In the event you’re really concerned about energy, use paper tape for all repairs. Finish the repair with several coats of drywall compound. Sink the screw head slightly below the surface of the drywall so it can be coated with spackle. Using a degree, measure a straight line throughout the top and backside of the damaged part.
Apply joint tape to the borders of the patch. Sand your patch area easy. A putty knife, spackle, or joint compound can restore wall injury that ages a room. Then cut out the part with a drywall noticed or utility knife. Drywall knife to use the primary layer of drywall compound over the tape.
Sand the surface clean around the gap. The commonest kind of drywall repair actually would not require a patch. Sand the wall smooth then clean off any particles. Joint tape is product of mesh and strengthens the bond between the patch and the wall, reducing movement and serving to to prevent future cracks.
After the compound dries, add a second thin coat of compound over the taped area. Put on protective clothing, work gloves, goggles and a mud mask when working with drywall. Use a nail bar to pry off the damaged section of corner bead. Subsequent, peel the paper backing off the back of the patch and place it over the hole so that the mesh surface faces outward.
Once the first coat of plaster is dry, give it a light hand sand and mud the surface clean with a rag. Drywall injury that extends throughout a number of wall studs requires extra in depth reinforcement and repair. Remember that to get a easy finish, it takes repeating the process two or perhaps even 3 times, letting it dry and sanding it smooth between every step.